The design of TV background wall should pay attention to four problems

First, the design and precautions of the TV background wall

In order to be aesthetic, personal and economical, people have made an article on the material of the wall during the renovation. The brick wall is also increasingly replaced by wooden walls, plasterboard walls, marble walls and glass walls. . As a result, in the installation work of the TV, it also brought a lot of trouble.

a, first say gypsum board wall: gypsum board shows that the white point is made of lime and mesh cloth, the bearing capacity is very poor, when decorating, the decoration master must make a whole piece of wood in the place 90cm from the ground (Specifications According to the size of the TV set, the minimum is not less than 60*60cm and the thickness is not less than 1.2cm). In this case, the TV shelf is directly screwed to the wooden board, eliminating the need to install the TV hanger later. Look for the keel everywhere, make the new wall into a honeycomb coal, or worry about unemployed installation!

b. The installation of the wooden wall is slightly better. As long as the thickness is more than 12mm, the wood screws are used when loading. There is no problem at all. Colorful carved wall

c. Marble wall: When drilling, be careful, it is easy to break, especially with grain. It is best to use a glass drill to complete the professional driller (not to be difficult for you to install the TV master, everyone is in trouble), the marble wall is no problem.

d, glass wall, everyone knows that the glass is fragile, can not bear the weight of the TV set of 30 ~ 40 kg, even if you put the TV rack, it may be no problem at that time, after ten days and a half months, there is glass Broken, we have encountered such a thing. The correct way to do this is to buy a few plastic washers (note that the thickness is thicker than the glass of the glass wall), first measure the relevant size, determine the hole in the shelf to be set on the wall, and then drill the glass on the glass. Hole, and finally drill the brick wall with impact drill. It should be noted here that the hole on the glass must be larger than the big point on the brick wall (the specific size is larger than the diameter of the washer). Do not let the washer and the hanger press when installing. On the glass.

Second, the line hole and the patch panel TV magic block background wall magic block background wall to join

For the sake of aesthetics, more and more users are now adding wire holes when designing the TV background wall. In this case, it is neat and safe, but some users are looking for informal home improvement companies to renovate, although they also consider This, but the effect is sometimes not ideal, some holes are too small, it is very difficult to thread, some holes exist in the joints, always stuck in the quilt, and some of the holes open too low, did not play Corresponding effect, the correct way is, the hole is replaced by PVC pipe. When the PVC pipe is directly buried in the wall, the size of the hole is preferably 70mm or more. The height of the upper hole is generally about 120cm from the ground, and the lower hole is generally about 30cm. .