The toilet is a common sanitary ware in our life. The installation of the toilet also requires various calculations and predictions. Generally, the installation master will first check the sewage pipeline firstly to see if there are any mud and sand, waste paper and other debris in the pipeline. Also check whether the floor of the toilet installation is horizontal or not. If the ground is found to be uneven, the toilet should be installed. Level the ground. The following small series will tell you about the side-seat toilet installation steps to solve your toilet installation problems.
1. The water outlet requires the installer to handle the leveling. The bottom outlet of the toilet should be equipped with a special flange for the toilet seat, or the glass glue and the water outlet are evenly connected. The bottom of the toilet is glued to the periphery, and the gap between the toilet and the wall is evenly placed. Correct and steady.
2. After the toilet seat is in place, the water is required to have no leakage, the water level is correct, the flushing is smooth, the switch is flexible, and the cover is stable.
3. Today, the installation of the toilet is generally not equipped with anchor screws, but the reserved holes on the toilet should be blocked with glass glue to prevent the taste.
4. If you need to install the anchor screw, first use the special sealant installed in the toilet to spread evenly on the outer 2CM of the base of the toilet base. The drain of the toilet should be facing the central position of the drain pipe. The position of the expansion bolt on the left and right sides of the toilet, take off the toilet, punch, and bulge the bolt. It should be noted that this newly-punched expansion bolt is embedded in the hole and may break the waterproof layer. It is recommended to pre-embed the expansion screw. At the same time, fill the seal around the hole, then bury the bolt, first screw the expansion bolt, let the expansion bolt completely release, strengthen its tension, then screw the upper screw, put the toilet Then screw the screws directly to the cap to maintain the overall appearance.
5. At the intersection of the toilet bowl and the outer surface of the ground surface, because the toilet bowl and the surface are not integrated, the joint seal transparent sealant can be used to stir and seal the outer mouth of the toilet to keep it intact with the ground surface. It is also possible to block the partial toilet water from the outside of the toilet.
6. After the toilet is installed, wait until the glass glue (soot) or cement mortar is solidified before releasing the water. The curing time is generally 24 hours.
7. Install or commission the water tank fittings. First check the water pipe, drain the water for 3-5 minutes to ensure the cleanliness of the water pipe, install the angle valve and the connecting hose, then connect the hose to the installed water tank fitting inlet valve and press the water source to check the water inlet. Check whether the valve water inlet and sealing are normal, check whether the installation position of the drain valve is flexible, whether there is any jam or leakage, and check whether there is any leaking inlet valve filter device.
After these steps, the side-seat toilet is installed. Is it not as complicated as I thought? I hope this knowledge can help you solve the trouble of toilet installation.
Exposed Shower Valve
Exposed Shower Valve is the simplest Shower Faucet. Single lever independently operate, automatic mixed cartridge design. Durable ceramic cartridge can guarantee 500,000 cycles no leaking. The thickness of electro plating reaches to 8 to 12 microns. The surface remains bright and durable even after passed 48 hours spray salt testing.
Exposed Shower Valve
Exposed Shower Valve,Hand Shower Faucet,Hand Held Shower Heads,Hand Shower,Shower Faucet
SHENZHEN KING OF SUN INDUSTRY CO.,LTD , https://www.handyfaucet.com