Many households usually use different grades of tile to decorate the walls and floors of their rooms. The high-grade decorative tiles have many excellent features. However, in the face of a dazzling market for materials, consumers are often at a loss.
Visually measure the appearance and size of the tiles
There are several elements to choose a tile: color, size, texture, appearance. When choosing, do a comparison. Take a tile of 300x300 size as an example. Select 6 to 10 bricks from a box of bricks on the floor (this type of brick uses about 11 pieces per square meter). Look at the color first. Full and consistent, good quality tiles should be no color difference; uniform size, horizontal and vertical is the requirements of the tile specifications, if the uneven material will greatly affect the quality of construction; tile texture should be smooth, smooth, visual inspection should not be uneven Appearance is also an important factor, there is no drop angle, porcelain no defect is the most basic requirement.
Understand the use of tiles
Take Taiwan-made tiles as an example, first of all its water absorption is very low, only 0. l%, which is 5-30 times lower than the natural stone's water absorption rate, can be used for years without discoloration and fading.
The wear resistance is the basic feature of the tile. After it is fired at high temperature, its hardness can reach 8 degrees, so the texture is very hard and can meet the requirements of the room without using function. Acid and alkali can effectively prevent the acid in daily life. Alkali infringement will not cause natural stone to “eat color†phenomenon, and it is easy to clean without leaving stains.
Paved in the correct order
There are many consumers who think that ceramic tiles have been skewed and dropped off after they are affixed. This is due to the fact that the construction process is not strictly followed by the process, and the quality of the selected auxiliary materials is the reason. The pavement construction process can be divided into several step:
1. Clean the wall and floor surface, smooth the floor with cement mortar, the ratio of wall cement to sand is 1:4, and the ratio of ground cement to sand is 1:3.
2. Calculate the number of tiles, determine the paving base line, and lay them from bottom to top along the wall. The seams are 1-3mm, and the tile spacing can be adjusted according to the actual area so that the whole brick is used at the corners, which is time-saving and beautiful.
3. After the tile is placed, tap the surface with a rubber mallet to make it stick and use the level test.
4. After the tiles are cured and stuck, use white cement to caulk and wipe them clean.
Tile cement room upscale tile tile specification tile adhesive acid tile
Elevator Traveling Cable,Best Elevator Traveling Cable,Lift Travelling Cable,Elevator Traveling Cable Fiber Optic
MAURER TECHNOLOGIES CO., LTD. , https://www.maurer-elevator.com