The most headache of wooden furniture is deformation and cracking. How to solve it? Let the traditional furniture craft master Mr. Wang Xiulin give you a few tricks! Those who have been to the timber market may notice that there is a deep accumulation of water at the bottom of the containers that have transported the wood. In fact, most of this water is oozing out of the shipped wood. In this regard, Wang Xiulin said that the tree has the original tension factor in the growth process, and after the felling, it contains a lot of water. If it is not used for drying, it will be used to make furniture, leaving the “residual†growth tension factor of the tree, just like It is the "regular army" and "guerrillas" who come to fight. The residual power and tension are not the same. If the treatment is not good, there will be a series of problems. Especially for the furniture sold in the northern market, wood drying is a must. The purpose of this is to remove a big hidden danger in the finished furniture. On how to prevent furniture from cracking and cracking, Wang Xiulin pointed out the points that should be paid special attention to in the production of furniture. He said that the southern furniture should be deeper in the process of making the groove, and the side groove should be kept a little wider. Do not leave the expansion joint, including the horizontal seam, and do not leave the four. In the winter, the water will be pulled out naturally. This is just right, if not, the face will be drawn. Wang Xiulin believes that the most critical issue in the production of furniture is the choice of wood texture. The facial panel should be used horizontally in any case. Do not use cross-hair and cross-hair crossover. The inner panel and the door panel should be the same. The furniture that is transported to the north by the South, the inner plate should be thicker, and the belt can be worn more and deeper. Nowadays, many furniture belts are the same width, which is more likely to cause problems. Therefore, it is necessary to wear the belt with the size of the head, and the texture should be worn in the opposite direction. For example, the furniture such as the Arhat bed is actually very simple to handle. You can make an eye in the center of the wooden heart (center) at the leg and leg. This is called the drain. In addition, southern furniture should be quickly dyed after it reaches the north. The main work of the producers should be used in the process, and learn to conform to the wood and guide the wood. What is guidance? To say that simplicity is the constraint, just as educating children in the family, it is impossible to follow him smoothly, and it must be guided and restricted. Therefore, wearing the furniture in the opposite direction is a constraint on the wood. If it is too tight to wear, it will vent in other directions. Like a human being, if the tube is too strict, it must be released elsewhere. Its solid wood and human nature are no different. Many woodworkers don't understand it. He is not willing to do it. It is too troublesome. In fact, the place where mahogany furniture makes a big fuss is in texture and structure. For example, Wang Xiulin said that many people admire the single-board furniture is a mistake, and it is impossible for the single-board furniture to go from the south to the north. He suggested that the single-board wood should be peeled from the middle before being glued, and there will be no problem of deformation cracking. After the break in the line, the riddle is very analogous to this. Mystery: playing a Chinese movie celebrity, the answer: Xie Jin, homophonic is the meaning of "venting".
Hexagonal Wire Mesh,Hexagonal Net,Galvanized Hexagonal Wire Mesh,Hexagonal Steel Wire Mesh
ANPING HONGYU WIREMESH CO.,LTD , https://www.hongyufence.com