Solar street light battery installation:
   1) Remove the dirt and other debris in the cement tank where the battery compartment is placed in the foundation of the solar street lamp to ensure that the drain hole is not blocked by foreign objects ;
   2) Check whether the battery compartment is damaged, and at the same time check whether the battery voltage is normal. Yangzhou Zhongmei New Energy Lighting has learned that if there is an abnormality, it is judged as a non-conforming product and installation is prohibited. Wrap the two ends of the sheathed wire with insulating tape.
   3) Disassemble and assemble the battery compartment and lift it into the pre-laid foundation with a crane, then put two double steel wire hoops on the connecting hose, pass the battery wire through the prefabricated pipe of the ground cage, and put the prefabricated pipe on Evenly apply a layer of 7091 sealing silicone, insert the other end of the connecting hose into the root of the prefabricated pipe, and use a flat-blade screwdriver to tighten the bolts on the double steel wire hoop. Yangzhou Zhongmei New Energy Lighting learned that after the battery cable was passed out of the prefabricated tube, a piece of threading hose was put on, and two double steel wire hoops were put on the threading hose to evenly coat the prefabricated tube. After a layer of 7091 sealed silicone, insert the threading hose into the root of the prefabricated tube , use a flat-blade screwdriver to tighten the bolts on the double steel wire hoop, and finally fix the battery cable at the mouth.
   4) Remove dirt, fine sand and other impurities in the foundation where the cover plate is placed ;
   5) Raise the cover plate, place it in the foundation and place it steadily. When placing the cover plate, avoid the sediment around the foundation falling into the foundation ;
   6) A mixture of asphalt and fine sand ( asphalt: fine sand = 1 : 3) covers the cover plate and 40 mm around the cover plate ;
   7) Fill with clay or Sanhe soil. When filling clay or triad, fill 10cm each time, tamping firm until it is 10cm above the ground ;
Melamine Particle Board is mainly used for furniture and carriage of bus, train.The bace&back are the Veneer surface, such as Okoume, Bintangor, Pine, Birch, Poplar, Pencil cedar, Maple, Cherry, White Oak, Sapele, Beech, Red Oak, Ash etc.Melamine paper is the most popular to be as the face board, it is abrasion resistant, heat resistant, fouling resistant, clean is simple.The Engineering wood is also as the face and back surface. It is more cheaper and beautiful, can reach the same wood grain effect as the veneer surface.And we have High Quality Particle board .LULI Group Co. Ltd, well known as the leading manufacturer for wooden, steel and paper products, located in Shouguang, Weifang, Shandong, China. Since the foundation in 1985, it focus on the production of Plywood , venner, MDF , Particle Board , Door skin , Blockboard , Finger Joint Board, OSB , paper, Steel etc.And we have Outdoor Melamine Particle Board.
Melamine Particle Board Details:
size:1220*2440MM 1250*2000MM 1525*2440MM 1830*2440MM
THICKNESS:9MM-40MM
MATERIAL:POPLAR, COMBINE, PINE
GLUE:E0, E1, E2
CERTIFICATION:CARB, FSC, CE
Melamine Particle Board
Melamine Particle Board,Melamine Faced Particle Board,Outdoor Melamine Particle Board,Melamine Laminated Particle Board
Luli Group Co.,Ltd. , https://www.cnluli.com